The material showed no cracks on application to concrete blocks
Glass Beads
33 % by Wt
Titanium Dioxide
10.2 (as TiO2)(% by Wt.)
Flow Resistance
6
Calcium Carbonate and Inert Filler
35.1 %
Material
Petroleum Resin Blended with Power and Fillers
Minimum Application Temperature
200 Deg. C
Direction for use:
Heat the material to 180 - 200 °C in the pre-heater with adequate agitation till the material becomes a homogenized liquid. Ensure that the road surface is clean, free from dust and moisture. Heavy deposits of paints requires removal. For aged asphalt roads and concrete road's application of a primer coat is recommended for proper bonding of the material with the road surface ensure that the primer is thoroughly dry and void of solvent prior to application of the thermoplastic material. Do not hold thermoplastic above 180ºC for more than 6 hours do not heat the material above 220ºC at any point in time. The change in colour indicates that the material has been scorched owing to overheating and needs to be discarded. Drop-on glass beads must be immediately deposited after thermoplastic application.
Safety Information:
Minimise dusting of the material during use of personal protective equipment's like facemask, google, heat resistant gloves and protective clothing while handling the material is recommended. do not inhale product or fumes, do not ingest. avoid eye contact, if contacted, wash copiously with water. contact of the molten product with skin would lead to thermal burns, flush with cold water, do not remove material as it would lead to very tissue damage. Please refer the material safety data sheet prior to using the product.
